Avenview HDM-C6VWIP-SET Spezifikationen PDF herunterladen (Seite 17)

atrix Switching Control

Command Matrix set TX1 RX1 RX2, TX2 RX3 RX4,...

Return Matrix set: TX1 RX1 RX2, TX2 RX3 RX4,...

Note Route one or Multiple TX on one or Multiple RX. Each individual TX and its routed RX or RX’s compose a re-

cord, and should be separated by a commas. Use NULL after a TX and any RX units from this TX will discon-

nect. Matrix commands cannot be sent when an RX is in video wall mode, first remove the RX from the video

wall or use the vw change command

E.g.: “matrix set Source1 Screen1 Screen2” sends TX with alias Source1 to RX’s with alias’ Screen1 & Screen2

Command matrix get

Return

the connected TX/RX information with below

format matrix information:

TX1 RX1

TX2 RX3

TX2 RX4

....

Note Obtain matrix information. Based on current TX/RX in the network, re-construct the network topology

and feedback to the third-party controller.

The Telnet protocol can be used to send configuration settings, matrix switching and video wall commands to the

CTRLPRO-VWIP system.

Commands can only be issued to the CTRLPRO-VWIP by IP using port 23.

The default IP address of the CTRLPRO-VWIP is 192.168.11.243 – in default configuration commands should be sent

to this IP address.

Video-Wall

Command vw add vw-name n m tx

Return videowall item vw-name create and assign tx to it

Note Create a video wall configuration, n and assign a TX.

E.g.: “vw add wall1 2 2 Source1” creates a 2x2 video wall named “wall1” on the TX with the alias Source1.

Command vw add vw-name n m tx

Return videowall item vw-name removed

Note Remove a video wall configuration.

E.g.: “vw rm wall1” removes wall1 configuration from the

Command vw add vw-name tx1 x y rx2 x y

Return videowall item vw-name configuration added:

rx1 posion1

rx2 posion2

...

Note Configure the video wall vw-name and add the corresponding RX’s in the given positions, this will set up many

RX and at once. Position (format): x y, represents a location, such as a 2 x 2 video-wall with 2 rows, and 2

columns.

E.g.: “vw add wall1 Screen1 1 1 Screen2 1 2 Screen3 2 1 Screen4 2 2” Sets the RX units with alias’ Screen 1 to 4,

to the noted x y positions in the video wall. Note a video wall by the name of wall1 must have already been

created using “vw add wall1 1 2 tx1” before this command can be used.

CTRLPTO-VWIP CONTROL PROTOCOL

www.avenview.com

Page 15

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Kommentare zu diesen Handbüchern

Keine Kommentare

Avenview HDM-C6VWIP-SET Spezifikationen Seite 17

Kommentare zu diesen Handbüchern