Avenview RTERM Series Bedienungsanleitung PDF herunterladen (Seite 24)

www.avenview.com

Wprt Intensity

Normal, blank, dim, blank / dim

Block End

Causes the terminal to send a block of data to the computer with a line terminator as an

ASCII US character and block terminator as an ASCII CR character (US / CR), or with line

terminators as ASCII CR and LF character and the block terminator as an ASCII ETX

character (CRLF / ETX).

Wprt Reverse

Sets the write-protected characters to appear in reverse (dark characters on a light

background).

Wprt Underline

Sets the write protected characters to appear underlined.

Ptr Baud Rate

Sets the SERIAL 2 port baud rate to 75, 150, 300, 600, 1200, 2400, 4800, 7200, 9600, 19200,

38400, 57600, 76800, 115200, 230400, 460800.

Ptr Data / Stop

Bits

Through the SERIAL 2 port ,the terminal to send and receive 8-bits data with one stop bit or

two stop bits, or 7-bits data with one stop or two stops bits.

Ptr Partly

Causes the terminal to send the data to the SERIAL 2 port with none, odd, mark, even, or

space parity.

Ptr Xmt

Hndshake

None, DSR, Xon / Xoff, Both

Ptr Rcy

Hndshake

None, DTR, Xon / Xoff, DTR/Xoff

On the tabs setup menu screen, the terminal’s current tab stops are indicated by uppercase T’s displayed

along a line of periods that mark each column position.

(1) A tab stop in columns 2 through 78 is shown as a T in the upper line of periods

(2) A tab stop in columns 79 through 132 is shown as a T in the lower line of periods

You can easily determine where tabs are set by moving the cursor across the line and reading the column

number displayed on the right side of the screen.

Clear and set tabs anywhere on the line, as follows:

(1) To move the cursor across the line, press or

(2) To either clear or set (toggle) an individual tab stop at the cursor position, press

(3) To clear all tabs, press

(4) To set tabs to the default setting (every eighth column), press

Note: A tab stop cannot be set to column 1.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 74 75

Keine Kommentare

Avenview RTERM Series Bedienungsanleitung Seite 24